Linear Transport Module Vertical

The following modules are required for the assembly of the LTM-V linear transport module:

• 1 x drive module
• 1 x deflection module
• Up to 5 middle modules

The required working length is determined by the number of middle modules to be installed for each LTM-V. It is between 720 and 3720 millimeters depending on the number of middle modules.

There are two workpiece carrier sizes:

• 100 x 120 mm (width x length)
• 180 x 120 mm (width x length)

The width of the LTM-V is defined by the selected size, as this side moves across the running direction of the system. Special widths are available upon request.
The hard-anodized aluminum workpiece carriers are fixed to the toothed belt. We will also manufacture a drilling pattern for customer cavities.

Consists of these components:

• Mounting kit
• Planetary gearing
• Servo motor
• Afag SE-Power servo controller

On customer request, we will also install commercial drives, such as B&R, Siemens or Beckhoff. 
These are provided by the customer.

• Easiest programming via PC, USB and RS-232 interface
• Parameterization and commissioning at the factory
• Setup in a few minutes
• 250 positions
• Driven via digital inputs/outputs, profi bus, CANbus, EtherCAT